Model X3C26P1-03S
Rev C
Peak Power Handling
High-Pot testing of these couplers during the qualification procedure resulted in a minimum breakdown voltage of
0.81Kv (minimum recorded value). This voltage level corresponds to a breakdown resistance capable of handling at
least 12dB peaks over average power levels, for very short durations. The breakdown location consistently occurred
across the air interface at the coupler contact pads (see illustration below). The breakdown levels at these points will
be affected by any contamination in the gap area around these pads. These areas must be kept clean for optimum
performance. It is recommended that the user test for voltage breakdown under the maximum operating conditions
and over worst case modulation induced power peaking. This evaluation should also include extreme environmental
conditions (such as high humidity).
Orientation Marker
A printed circular feature appears on the top surface of the coupler to designate Pin 1. This orientation marker is not
intended to limit the use of the symmetry that these couplers exhibit but rather to facilitate consistent placement of
these parts into the tape and reel package. This ensures that the components are always delivered with the same
orientation. Refer to the table on page 2 of the data sheet for allowable pin configurations.
Test Plan
Xinger III couplers are manufactured in large panels and then separated. All parts are RF small signal tested and DC
tested for shorts/opens at room temperature in the fixture described above . (See “Qualification Flow Chart” section
for details on the accelerated life test procedures.)
USA/Canada:
Toll Free:
Europe:
(315) 432-8909
(800) 411-6596
+44 2392-232392
Available on Tape and
Reel for Pick and Place
Manufacturing.
相关PDF资料
X3C26P1-30S COUPLER 90DEG 2650-2800MHZ 30DB
X3DC07E2S DOHERTY COMBINER 728-768MHZ SMD
X3DC08E2S DOHERTY COMBINER 862-894MHZ SMD
X3DC09E2S DOHERTY COMBINER 920-960MHZ SMD
X3DC18E2S DOHERTY COMBINR 1805-1880MHZ SMD
X3DC19E2S DOHERTY COMBINR 1930-1990MHZ SMD
X3DC21E2S DOHERTY COMBINR 2110-2170MHZ SMD
X9470V24I IC BIAS CTRLR RF PA 24-TSSOP
相关代理商/技术参数
X3C26P1-03S-CT 制造商:Anaren Microwave 功能描述:RF HYBRID COUPLER
X3C26P1-03S-R 制造商:Anaren Microwave 功能描述:RF HYBRID COUPLER
X3C26P1-30S 功能描述:信号调节 2300-2900MHz IL.10dB VSWR:1.15 -55 to 95C RoHS:否 制造商:EPCOS 产品:Duplexers 频率:782 MHz, 751 MHz 频率范围: 电压额定值: 带宽: 阻抗:50 Ohms 端接类型:SMD/SMT 封装 / 箱体:2.5 mm x 2 mm 工作温度范围:- 30 C to + 85 C 封装:Reel
X3C26P1-30S-CT 制造商:Anaren Microwave 功能描述:RF DIRECTIONAL COUPLER
X3C26P1-30S-R 制造商:Anaren Microwave 功能描述:RF DIRECTIONAL COUPLER 制造商:Anaren Inc 功能描述:X3C26P1-30S-R
X3C302N2LB 制造商:SAIA - BURGESS ELECTRONICS INC. 功能描述:Catalogue / X3C302N2LB
X3C302N2LBJ32 制造商:SAIA - BURGESS ELECTRONICS INC. 功能描述:Catalogue / X3C302N2LBJ32
X3C302N2NB 制造商:SAIA - BURGESS ELECTRONICS INC. 功能描述:Catalogue / X3C302N2NB